Climatec Fleet Pickups

White Colorado pickups with work caps and ladder racks, and one design that has to land in the same place on every one of them. On these Climatec trucks, a large chevron in blue, teal and gray straddles the rear door and the bed, the “Climatec, A Bosch Company” logo sits on the front door, and the work cap carries everything a customer or an inspector needs to read. To plan lettering or partial graphics for your service trucks, call us at 214-585-0050.

White pickup with Climatec blue and teal fleet graphics on the doors and work cap
Fleet
Climatec, A Bosch Company
Vehicles
White Colorado pickups with work caps
Graphics
Door chevrons, door logo, cap lettering, license and unit lines
Photo record
19 August 2025

Where Each Piece Sits on the Truck

Fleet graphics on a pickup are a layout across several separate surfaces, and this design uses all of them:

  • Front door: the Climatec logo and “A Bosch Company”, with two license lines in small type near the sill.
  • Rear door and bed side: the chevron, built from blue, teal and gray bands that meet at a point near the door gap.
  • Cap side: “Building Automation | Energy Solutions | Security | Life Safety” over the website and phone number.
  • Cap rear doors: the logo across both doors, the license lines on the left, a unit number on the right, the website and phone number along the bottom, and a teal stripe at the base.

The rest of the truck stays white. That keeps the graphic count per vehicle manageable across a fleet and leaves the chevron as the one shape people remember.

Climatec fleet pickup with door graphics and an orange ladder on the rack

A Chevron Across the Gap

The chevron is the part that takes the most care, because it is not on one panel. Its bands start on the rear door, cross the gap between the cab and the bed, and finish on the bed side, and on the driver’s side the teal band passes right over the fuel door. Each band has to meet its other half across that gap at the same angle and height, or the point of the chevron breaks. Our photos show it lined up on both sides of the truck.

The Cap, Where the Small Print Lives

The rear of a work cap is two doors that open down the middle, and the logo spans both, split at the seam. The license lines and the unit number sit to either side of the center latch, which is where a fleet manager, a customer or an inspector looks for them. Small type like this is the least glamorous part of fleet lettering and the part that most needs to be exactly right, since the numbers on the truck have to match the numbers on file.

Other trucks and a van in the same livery are parked around the one in our photos, which is the point of a fleet design: from across a parking lot, every unit reads as the same company.

Frequently Asked Questions

Yes. On the Climatec trucks the chevron starts on the rear door and finishes on the bed side, with each band lined up across the gap.

Yes. On these pickups the cap side carries the services line and contact details, and the cap’s rear doors carry the logo, the license lines and a unit number.

Graphics for Service Trucks

A service fleet is seen every day in customers’ driveways and on the road, so every unit should match the one before it. We handle fleet graphics installation for vans, pickups and trailers, and an orange and black design matched across cargo vans and pickups is the Dallas Plumbing fleet.

Send the unit list and where the trucks are parked to sales@graphicinstallationteam.com, or call us at 214-585-0050.